STEM Ranger
  • Introduction
  • Notes before beginning
  • Safety
  • Arms, Motors and ESCs
  • ESC & Wire Harness Connectors
  • Landing Gear
  • Base Frame Assembly
  • Mounting the Naza Flight Controller
  • Remote Control (FS-I6S) Set up - Naza
  • Software Installation
  • Setting up the flight controller
  • When ready to fly
  • Waypoint Module (Optional)
  • Compass Calibration
  • Pre-flight
  • Motor start - first flight
Powered by GitBook
On this page
  • Warning: Do not install propellers until just prior to flight!
  • Ensure propellers are removed during the building process and whenever troubleshooting.
  • Note: Ensure the battery is NOT connected if you have the propeller on. Make sure you REMOVE the propellers before connecting the battery.

Was this helpful?

Safety

Warning: Do not install propellers until just prior to flight!

Ensure propellers are removed during the building process and whenever troubleshooting.

Note: Ensure the battery is NOT connected if you have the propeller on. Make sure you REMOVE the propellers before connecting the battery.

PreviousNotes before beginningNextArms, Motors and ESCs

Last updated 4 years ago

Was this helpful?