STEM Ranger - Pixhawk
  • Notes before beginning
  • Safety
  • Arms, Motors and ESCs
  • Wire Harness
  • Frame Assembly
  • Mounting the MRobotics Standard Pixhawk Flight Controller
  • Mounting the Durandal Version Pixhawk
  • Configuring the your Pixhawk
  • Post Configuration Checks
  • Propellers
  • Pre-flight
  • Arming and Flight
  • Telemetry and Autonomous Flight
  • Batteries and Charging
Powered by GitBook
On this page
  • ​Warnings /Disclaimer
  • Flight Area LayoutFlight area layout 2016 Update
  • Lithium Battery WarningLithium Battery Safety
  • OnPoynt Hold Harmless OnPoynt
  • FPV / Video Transmitter Regulations -REGULATORY NOTICE
  • Register Your Drone
  • FAA Rules for EducatorsFAA Special Rule for Model
  • FAA Guidance for Educators

Was this helpful?

Notes before beginning

​Warnings /Disclaimer

Flight Area LayoutFlight area layout 2016 Update

Lithium Battery WarningLithium Battery Safety

OnPoynt Hold Harmless OnPoynt

FPV / Video Transmitter Regulations -REGULATORY NOTICE

Register Your Drone

FAA Rules for EducatorsFAA Special Rule for Model

FAA Guidance for Educators

Lay out all parts and ensure that everything is there and that you have a safe place to store it all. Begin build with the Torx T8 or Allen driver bit in place. Initial work will be started on the lower face plate (upper face plate has the triple chevron and large central opening).

All frame parts laid out.

​

NextSafety

Last updated 4 years ago

Was this helpful?