STEM Ranger - Pixhawk
  • Notes before beginning
  • Safety
  • Arms, Motors and ESCs
  • Wire Harness
  • Frame Assembly
  • Mounting the MRobotics Standard Pixhawk Flight Controller
  • Mounting the Durandal Version Pixhawk
  • Configuring the your Pixhawk
  • Post Configuration Checks
  • Propellers
  • Pre-flight
  • Arming and Flight
  • Telemetry and Autonomous Flight
  • Batteries and Charging
Powered by GitBook
On this page

Was this helpful?

Frame Assembly

PreviousWire HarnessNextMounting the MRobotics Standard Pixhawk Flight Controller

Last updated 4 years ago

Was this helpful?

NOTE: we recommend orienting the frame with the red motor mounts towards the REAR of the drone (think taillights) but as long as they are two of the same color along the long axis is does not matter.

NOTE: your wire harness may be different than the one pictured here. just be sure to connect red wire to red wire and black to black.

Connect red and black wire harness wires to the corresponding ESC power wires.

Connect ESC signal wires extensions to each ESC signal wire.

Feed the signal wires up through the larger opening in the front end of the frame

NOTE: we recommend orienting the frame with the red motor mounts towards the REAR of the drone (think taillights) but as long as they are both along the long axis is does not matter.

Install all 4 standoffs and then secure the top plate to hinge and joints with screws.