Top Plate, Antenna and LEDs

Step 1 Top Plate

Now you can add the top plate using the M3 screws.

Step 2

Keeping your antennas out of your props will prolong the life of your antennas and prevent sudden signal lose. Use the zipties and heat-shrink provided to keep your antennas safe!

Step 3

Carbon fiber conducts electricity so it always a good rule of thumb to have something between components and carbon. We supply double sided sticky tape and zipties to secure everything. Cut your adhesive pads into sections like shown for adding your LEDs.

Step 4

Adding LEDs by peeling the tape from the adhesive and sticking them to the tape.

!! Be Careful !!

Pay special attention to pins when plugging connectors in. They can get bent if done incorrectly downing the drone before ever getting off the ground.