The Hawk
  • The OnPoynt Hawk or Longbow- NAZA
  • Notes Before Beginning
  • Safety
  • Arms and Motor Mounts
  • Lower Plate
  • Mounting the Arms
  • Mounting the Naza Flight Controller
  • Landing Gear and Payload Plate
  • Software Installation
  • Setting up the flight controller
  • FS-I6S Set up - Naza
  • Propellers
  • Pre-flight
  • Compass Calibration and Arming the Motors
  • Done ! Let's Fly
Powered by GitBook
On this page

Was this helpful?

Propellers

PreviousFS-I6S Set up - NazaNextPre-flight

Last updated 4 years ago

Was this helpful?

Do NOT install the propellers until you are preparing to fly.

Your kit includes 2 pairs of propellers, 2 rotate clockwise (CW) and 2 counter clockwise (CCW). There are small numbers on the leading edge of each propeller, make sure the number are at the front, in the direction of rotation and that they visible from the top.

Find the size spacer that fits the motor shaft.

Press the propeller down on top of the spacer.

Note the numbers on the top of the propeller.

NOTE: direction of rotation for motors 1 and 3 is counter clockwise and for motors 2 and 4 is clockwise.

Make sure the leading edge with the numbers on the edge are in the direction of motor rotation.

If the motor comes with a propeller washer make sure it is installed under the propeller nut.

​

​

A socket is best for tightening the propeller nuts but a pliers will work as well.