STEM Box
  • Introduction
  • Safety
  • Notes Before Beginning
  • Instructions Steps 1 - 13
  • Installing the motors
  • Installing the ESC
  • Installing the flight controller
  • Installing the LED
  • Installing the GPS
  • To finish the build
  • Software Installation
  • Setting up the flight controller
  • When ready to fly
  • Way Point Module (Optional)
  • Compass Calibration
  • Pre-flight
  • Motor start - first flight
Powered by GitBook
On this page

Was this helpful?

Installing the LED

PreviousInstalling the flight controllerNextInstalling the GPS

Last updated 5 years ago

Was this helpful?

Step 27: The LED wire comes up through the rectangular hole on the bottom right of the box. Use a sticky pad on the back of the LED to secure it to the rear right of the box on either the left or the right. Plug the LED into the LED on the NAZA.