STEM Box
  • Introduction
  • Safety
  • Notes Before Beginning
  • Instructions Steps 1 - 13
  • Installing the motors
  • Installing the ESC
  • Installing the flight controller
  • Installing the LED
  • Installing the GPS
  • To finish the build
  • Software Installation
  • Setting up the flight controller
  • When ready to fly
  • Way Point Module (Optional)
  • Compass Calibration
  • Pre-flight
  • Motor start - first flight
Powered by GitBook
On this page

Was this helpful?

Motor start - first flight

PreviousPre-flight

Last updated 5 years ago

Was this helpful?

Turn the handheld transmitter ON by pressing and holding center button. To start motors, simultaneously take both switches down and to the center.

Note: If the throttle is not moved above idle the motors will shut off after 3 seconds. Simply restart the motors by moving both sticks down into the center again.

Turning handheld transmitter on.